Matrox Electronic Systems Matrox RT.X2 - Manual (Page 94)

86
Chapter 4, Setting Up Realtime Effects with Adobe Premiere Pro
$
Border Type Allows you to select the type of border you want ( None ,
Flat , Gradient , or Alpha Edge ). Click the triangle on the right to expand
the list of border types.
¦ Note The Alpha Edge border type is for use with alpha-keyed graphics
only.
$
Border Width Use this control to adjust the border along the X and Y
axes simultaneously. The higher the value, the wider your border becomes.
If you clear
Fixed Aspect Ratio , you can adjust each axis individually.
$
X Border Width Use this control to adjust the border along the X axis.
The higher the value, the wider your border becomes.
$
Y Border Width Use this control to adjust the border along the Y axis.
The higher the value, the wider your border becomes.
$
Border Inside Softness Sets the border softness on the inside edge of
your border. The higher the softness value, the less sharp the edge or border
becomes.
$ Border Outside Color Use the color picker or eyedropper to select the
color you want for your border, or the outside edge of your border if you
selected
Gradient as your border type.
$ Border Outside Transparency Sets the transparency of your border, or
outside edge of your border if you selected Gradient as your border type.
Levels range from opaque (0) to fully transparent (100).
¦ Note The next two properties ( Border Inside Color and Border Inside
Transparency ) are available only if you selected Gradient as your border
type.
$
Border Inside Color Use the color picker or eyedropper to set the inside
color of your border, which will create a gradient between this color and
the outside color of your border.
$ Border Inside Transparency Sets the transparency of the inside color
of your border.
$
Round Corner Size Allows you to round the corners on the edges of
your border.
$
Corner Point Offset Allows you to move the position of the corner
points of your border so that you can create various shapes for your 3D
DVE. Negative values bring the corner points towards the center of the clip,
while positive values move the corner points outward.
Click here to
select your
border type