MPI Technologies LaserJet 2100 - Manual (Page 11)

Printer Requirements:
The recommended memory configuration is as follows:
Requirement Minimum
installed
memory
Recommended
minimum memory
(simple text)
Recommended
minimum memory
(pages with overlays
or graphics)
A4/Letter simplex 8 MB 8 MB 12 MB
Printer Minimum Printer
firmware date code
IPDS DIMM
firmware(or later
versions)
HP2100 19990105 S93 162.084
HP JetDirect EIO (600 N J3111A/Ethernet)
HP JetDirect EIO (600 N J3112A/Tokenring)
HP JetDirect EIO (600 N J3113A/10/100Tx Eth)
HP settings:
1. Set the IP, Subnet Mask, and Gateway address on the JetDirect card.
2. The printer's PS wait time-out shall be set to 300 sec.
3. The JetDirect card's IDLE TIMEOUT shall be set to 3600 sec or 0 (zero).
4. Remember to power cycle printer to enable new settings.
4.1 AS/400 Settings for Version 3.1
To configure IPDS printing on AS/400 V3R1, you must use two commands:
- CRTDEVPRT
- WRKAFP2
4.1.1 Configuring PSF with CRTDEVPRT on V3R1
On V3R1, at the AS/400 command line, enter a command in the form:
CRTDEVPRT DEVD(HP_IPDS) DEVCLS(*RMT) TYPE(*IPDS)
MODEL(0) AFP(*YES) AFPATTACH(*APPC)
FONT(11)RMTLOCNAME(TCPIP) FORMFEED(*AUTOCUT)
TEXT('IDATA IPDS DIMM')
11