Multi-Link ML-001 - Manual (Page 15)

– 13 –
INSTALLATION
Account Number Programming
In order to program the account number, follow the procedures follow:
Press [PROG]
Press [MPIN] Enter
Programming
mode
Press [2]
Enter master
password to
programming
mode
3 beeps for valid
password. 1 long beep
for invalid password.
Select
password
programming
Press [0] Select to
add / change
account
number [0] = Add/change
account number
Step Keys Function Description Note
4
3
2
1
Enter [New 4-
digit Account
Number] This number can be a
combination of 0-9,
B,C,D,E & F.
To enter 0-9:
Enter by the keypad 0-9
directly.
To enter B,C,D,E,F:
Press [STATUS] and the
ARM light will stay on.
Then press the following
keys for the correspond-
ing letters (1=B, 2=C, 3=D,
4=E, 5=F).
Press [STATUS] to return
back to number-mode
when you want to input
numbers. The ARM light
will turn off.
You can toggle between
the number or letter mode
by pressing [STATUS]
when entering the
account number.
Enter the 4-digit
account number
given by the
central monitoring
station. Enter new
account
number
Enter [New 4-
digit Account
Number] 5 3 beeps if new account
number is accepted. You
will hear [Password
Accepted] Enter the new
account num-
ber again for
confirmation
HOME AUTOMATION
Part 2 Erase communication from Control Panel to Control Module
ZONE LED DESCRIPTION
Off Zone is not occupied by any control module
Flashes twice That means a remote has occupied that zone.
THIS IS NOT A CONTROL MODULE, THEREFORE, SHOULD NOT BE
ERASED.
Flashes once That zone is occupied by a control module. You may select this
zone to erase this control module.
Flashes once, That means this zone is occupied by a remote AND a control module.
then twice You may select this zone to erase the control module.
** Table F: Zone LED status for erasing control module.
1
2 To erase the
memory of the
control module Control module LED
will flash rapidly
indicating all the
memory is erased.
You may now
release the learn
button.
Remove the
control module
from the
electrical outlet
Press and hold
the learn button
on the control
module while
plugging in the
control module
to an electrical
outlet.
Once the memory of the control module is erased, all of its memory is cleared. If
you have other remotes / control panels controlling this control module, you need
to re-program those remotes / control panels.
Step Keys Function Description Note
– 44 –