Multi-Link ML-001 - Manual (Page 17)

Part 2 Learn signal from Control Panel to Control Module
HOME AUTOMATION
Control Module [1] is represented by zone LED 1
CONTROL MODULE
LOCATION
1 6
2 7
3 8
4 9
5 0
TRANSMIT
BUTTON [X]
1
2
Enter
Programming
mode LED on the Control Module
will flash indicating it is in
learn mode.
[6] to [0] Transmit an ON
signal for the
selected device
from the Control
Panel to the
Control Module. Refer to the
chart below to
determine which
button [6] to [0]
to press.
You should
transmit the “ON”
command for the
selected device. After [X] is entered, you
will hear [Device X On]
indicating you have trans-
mitted an ON signal for
device X, where X is the
Control Module Location.
The LED on the Control
Module should be off,
indicating it has learned
the signal, you may now
release the learn button
and the LED will stay on
again.
Press and hold
the learn button
on the Control
Module until its
LED starts to
flash.
Step Keys Function Description Note
This row :
Buttons for
Learning Control Module
– 15 – – 42 –
Window / Door Sensor is used to monitor doors or windows that
open and close. When these doors / windows are open or
closed, the sensors will transmit a signal to the control panel
to notify the user. These sensors consist of 2 parts, one is the
transmitter, the other is the magnet.
Before installing the sensor, remove the battery isolator by pulling out the yellow
tab. Once the isolator is removed, the corresponding zone LED on the control
panel will flash and buzzer will beep. If the magnetic contact is closed, the
beeping will stop.
Note:
- Both Window/Door Sensors have been programmed at the factory. They are
Zone 1 Sensor 1 and Zone 2 Sensor 1. Trigger the sensor and listen to the
beeping and zone LED to determine which one is zone 1 and which is zone 2.
Testing:
After mounting the sensor, test the sensor by opening and closing the door or
window. Open the door or window will result in the followng:
1. Beeping - The number of beep represents the zone number.
2. Zone LED flashing - Number of flash represents the sensor number.
Mounting the Sensor
The transmitters should be mounted on the door frame or window frame by
double sided tape. The magnet should be mounted on the door or window by
either double sided tape or screws. Make sure the magnet is aligned with the
red marking on the transmitter. If the surface of the frame is flat enough, double-
sided foam tape is sufficient, otherwise, it is recommended to screw the
mounting plate to the frame, then apply double sided tape. After mounting the
sensor, if the AAA+ logo is inverted, remove the front cover and rotate it so the
AAA+ logo is in the upright position.
INSTALLATION (ML-100A Only)
Installing Door / Window Sensors
Transmitter
Magnet
Double-sided
foam tape Mounting plate
and screws
(optional) Sensor Magnet on the left Magnet on the right