Marantz RC1400 - Manual (Page 20)

18
ENGLISH
USE PAGE 1
LEARN
1 2
LEARN
1 2
LEARN
PAGE 1 2
LEARN
PAGE 1 2
6 (When OK) (failed) (codes are full)
1 2
9 Confirm the OK is displayed and then the
display returns to the Preset Setting (P-
SET).
10 To set the manufacturer number for
another source device, repeat the
procedure in steps 4 to 8.
11 After the settings are completed, press the
M button r.
12 Press the buttons on the remote control to
check that the DVD can be operated
correctly.
Check the following points if the equipment
which was set does not operate properly.
• If there is more than one number in the
manufacturer number list, try setting a
different number.
• There may be some buttons which cannot be
used. Program the codes to the required buttons.
LEARN Mode
Programming the (PLAY) and Other
Control Buttons and Numeric Buttons
This remote control is capable of learning and
storing codes used by other remote controls
that you already own.
For codes which are not learned, the remote
control will transmit either the Marantz preset
codes from the initial settings, or remote codes
from another manufacturer’s AV equipment
which is set by the customer.
The receiver sensor for the remote control
signals is located at the top of the remote control.
This example shows how to learn the codes
from the remote control of a DVD player.
1
2 4
03.10.6, 4:17 PM Page 18