Marantz RC1400 - Manual (Page 43)

41
ENGLISH
SETUP
Setting the Lighting Time
• The LCD lights up when the LIGHT buttons
!5 are pressed. The LCD remains lit while
the pressed button is held down, and it goes
off when the button is released.
• The LCD continues to light up if another
button is pressed while it is lit or if pressed
within two seconds after the light goes off.
• The lighting time can be set in one-second
units from 0 to 60 seconds.
The LIGHT buttons have light-absorbing
properties that enable them to store light. If the
buttons are no longer illuminated in a dimly lit
e n v i r o n m e n t , b r i n g t h e b u t t o n s n e a r a
fluorescent lamp or other light source for a
s u f f i c i e n t a m o u n t o f t i m e . T h i s s h o u l d
illuminate the buttons again.
• The LIGHT buttons consist of a LIGHT1 and
LIGHT2 button, and they both perform the
same operation.
The factory default lighting time is set to 15
seconds.
This example shows how to set the lighting
time to 20 seconds.
1 Hold down the M button r for three
seconds or more.
The menu is displayed.
2 Press the > button y to display the
second page SETUP menu.
3 Press the D1 (LIGHT) direct button t.
The LIGHT is displayed on the LCD
4 Press the or cursor button @0 to set
the lighting time.
5 Press the OK cursor button @0 to enter the
lighting time.
6 Once the setting is finished, press the M
button r.
PAGE 1 2
2 3 4
LEARN
1 2 3 4
LEARN
1 2 3 4
03.10.6, 4:19 PM Page 41