Motorola CPCI-6115 - Manual (Page 100)

CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
Transition Module Preparation and Installation CompactPCI User I/O Connector
98
*Not connected on MXP version
5.5.4 CompactPCI User I/O Connector
Connector J5 is a 110 pin AMP Z-pack 2mm hard metric type B connector. This connector
routes the I/O signals for the PMC2 I/O signals, the IDE port, four asynchronous serial ports
and I2C. The pin assignments for J5 on the processor board and the CPCI-6115-MCPTM are
as follows:
(Outer row F is assigned and used as ground pins but is not shown in the table).
5 PMC1IO45 PMC1IO44 PMC1IO43 PMC1IO42 PMC1IO41 5
4 PMC1IO50 PMC1IO49 PMC1IO48 PMC1IO47 PMC1IO46 4
3 PMC1IO55 PMC1IO54 PMC1IO53 PMC1IO52 PMC1IO51 3
2 PMC1IO60 PMC1IO59 PMC1IO58 PMC1IO57 PMC1IO56 2
1 IPMI_PWR PMC1IO64 PMC1IO63 PMC1IO62 PMC1IO61 1
Signal Description
PMCIO:
PMC1IO(64:1) PMC1 I/O signals 1 through 64
Ethernet:
PORTn_TXP high side of differential transmit data
PORTn_TXN low side of differential transmit data
PORTn_RXP high side of differential receive data
PORTn_RXN low side of differential receive data
Table 5-7 User I/O Connector Pinout, J3 (continued)
Pin Row A Row B Row C Row D Row E Pin
Table 5-8 User I/O Connector Pinout, J5
Pin Row A Row B Row C Row D Row E Pin
22 DRESET_L COM4_TXD COM3_TXD COM2_TXD COM1_TXD 22
21 INTRQA COM4_RXD COM3_RXD COM2_RXD COM1_RXD 21
20 CS1FXA_L CS3FXA_L DA2 MXDI MXDO 20
19 Not Connected DIORDYA DA1 MXCLK MXSYNC# 19
18 DIOWA_L DA0 TMCOM1_L I2C_CLK I2C_DATA 18
17 GND DD14 DD15 DIORA_L Not Connected 17
16 DD9 DD10 DD11 DD12 DD13 16
15 DD5 DD6 GND DD7 DD8 15
14 DD0 DD1 DD2 DD3 DD4 14
13 PMC2IO5 PMC2IO4 PMC2IO3 PMC2IO2 PMC2IO1 13