Magellan eXplorist XL - Manual (Page 38)

30
Waypoints that are currently used in a route (discussed in the
next section) cannot be cleared. The receiver will warn you if you
attempt to do so.
Changing the name of the waypoint is the first option. Use the LEFT/
RIGHT ARROWs to move the cursor and the UP/DOWN ARROW
to select the characters. After changing the waypoint name or if
there are no changes to the waypoint name, press ENTER.
Make a changes to the position using the UP/DOWN ARROWs to
scroll through the number list, and use the LEFT/RIGHT ARROWs to
move left and right. Press ENTER to accept the changes. After all
changes are made to the position and elevation, press ENTER. In a
few seconds the changes will be saved and the receiver returns you
to the WAYPOINT screen of the edited waypoint. Any name changes
that you made under edit have been saved, replacing the former
name and/or coordinates.
If you attempt to edit a waypoint contained in a route, a warn-
ing message will appear: "WARNING - WPT USED IN ROUTE
ENTER TO CONTINUE." You must first delete the waypoint from
the route (or delete the route) before modifying the waypoint.
Deleting a Waypoint
Used to permanently remove a waypoint from your receiver’s memory.
MENU
Highlight
WAYPOINTS
Press ENTER
Use ARROW
KEYS to select
waypoint
ENTER ENTER
Highlight
DELETE
Press ENTER
Highlight YES to
confirm deletion
ENTER
Press MENU, use the UP/DOWN ARROWs to select WAYPOINTS
and press ENTER. Select the waypoint in the list you wish to delete,
then press ENTER to access the WAYPOINT screen. Now press ENTER
to access the function menu, highlight DELETE and press ENTER.
The receiver will now give you one last
chance to change your mind. If you are
sure, use the UP/DOWN ARROWs to
highlight YES and press ENTER. The
waypoint is now erased and you are re-
turned to the next waypoint in the list.
WARNING
NO
YES
DELETE DOCK