Magellan eXplorist XL - Manual (Page 46)

38
Replacing a Waypoint
This allows the destination (TO) waypoint of a leg to be changed to a
different waypoint.
Access the
ROUTE
MENU
Use ARROW KEYS
to highlight route to
be edited
ENTER
Highlight
EDIT
Press ENTER
Use UP/DOWN
ARROWs to select
the route leg
ENTER
Highlight
REPLACE
Press ENTER
ENTER
Use LEFT/RIGHT
ARROWs to select
"TO" waypoint
Access the ROUTE MENU and highlight the route to be edited. Press
ENTER to bring up the pop-up menu, highlight EDIT, and press ENTER.
Use the UP/DOWN ARROWs to view the leg to be modified. Press
ENTER to access the EDIT LEG menu, select REPLACE, and press EN-
TER.
A highlight bar appears for you to select
the new TO waypoint for this leg, replac-
ing the existing one.
Use the LEFT/RIGHT ARROWs to scroll
to the waypoint you wish to use as the
new destination for this leg of the route
and press ENTER.
The new TO waypoint must be different from the old (must have
a distance greater than 0.1 distance units from the "FROM"
waypoint)); the receiver will not replace a leg in this case but will
return to the leg screen you were viewing.
The destination has now been changed. The receiver has updated the
bearing and distance for this leg and displays it on the screen.
Press the DOWN ARROW. The following leg has also been changed.
The following leg now starts from the waypoint you designated as the
TO waypoint for the previous leg.
Navigating (Activating) a Leg
While navigating using a multileg route, one leg of the route is said to
be active. This is the leg that is currently being used to provide
navigational information. It is sometimes desirable to activate a different
leg, thereby changing the destination being navigated to.
REPLACE LEG 1
FROM JETTY
TO
BRG
1.58 n
m
DST
207`
WPOO3