MaxTech Transceiver - Manual (Page 30)

31
Load C ounter S creen
C: C lear / Res et – ~ / M E N U C C
Cou nt direc tion is not c hang ed. C ounter is reset to 0 if cou nt direc tion is s et to up, or
the c oun ter is res et to the load value if c oun t direc tion is set t o dow n. If the c oun ter is
disab led, then th is fu nc tion will enable the c ounter u sing the last c ount d irection s et.
The Counter is cleared and reset in this fashion when the unit is powered down.
ë
Us e ~ C C as an eas y to remem ber qu ick key c omb ination for f ast c ounter res et.
D : D isab le – ~ / M E N U C D
Counter is disabled and is not displayed on the main screen. W hile disabled the
cou nter does not cou nt.
L: Load – ~ / M E N U C L
Enables custom setting of the load count value
(des ired nu mb er to start th e coun t from , whic h is th en
loaded into the MultiMAX computer memory). The
def ault value is 3 6. M aximu m value fo r the c oun ter is
9999.
Loading a coun ter value while the c ounter is enabled
will set the main screen count to that value and
cou nting will contin ue in the las t direction set
(UP or DO W N).
N
T he load c ounter value is sh ared with the Intervalometer and M ultipop
functions. Setting a count in either of these functions also sets the load count value
for nor mal c ounter op eration.