MaxTech Transceiver - Manual (Page 49)

50
Technical Information
Specifications
W eight: 5.4 ou nc es w ith alkaline batteries
Dimensions: 1.4 inc hes deep x 2.1 inc hes wid e x 4.0 inc hes tall (b ody on ly)
Flexible antenn a = 2.4 inch es tall. 0.3 in ch es in d iameter
Batteries : 2 x AA (IEC :LR 6), 1.5 V b atteries, alkaline rec omm ended
Read the Getting Started sec tion, Pag e 13, f or mor e inform ation
AC Adapter Jack: 3 V DC unreg ulated, 0.3 A (3 00 m illiamp) or h igher
4.5 V DC regulated, 0 .2 A (200 milliamp ) or high er, (recom men ded)
Polarity = c enter p os itive, ou ts ide n egative
Male plug specifications: 1.3mm ID, 3.4mm O D, 1cm long
Input / Output Ports:
Size 3.5mm (1/8") mono miniphone
Maximum Input Voltage 2 50 V DC
PO RT 1 current handling 0.5 A (½ Am p), c urren t limited
PO RT 2 current handling 4.0 A for 0.00002 seconds (1/50000 second
or 20 microseconds)
0.25 A (1/4 Amp or 250 milliamp) continuous,
cu rrent lim ited
PO RT 1 polarity tip p ositive, n on-r evers ible
PO RT 2 polarity tip p ositive, r evers ible
PO RT 1 and Hot S hoe
Voltage present 3.3 VD C, 0.001 A (1/1000 A mp or 1 m illiamp),
regulated
PO RT 1 and Hot S hoe
trigg ering thres hold < 2.2 V
PO RT 1 and Hot S hoe
holding current 0.0005 A (1/2000 Amp or 50 microamps)
HOT S HOE NOT E #1: PO RT 1 and the hot s hoe are electric ally connec ted together .
A device attached to POR T 1 will trigger when the TRAN SMIT unit is triggered by the
hot s hoe. T his is not con trollable by the L key. W hile the device may trigger in sync
with the shutter, it will not be controlled by the MultiMAX. If the device is a high
voltage flash unit then the MultiMAX does not provide voltage protection to the camera
in this situation. For normal operation do not use POR T 1 to trigger a high voltage
flash on a T RA NS MIT unit un less nothing is attach ed to the hot s hoe.