MaxTech Transceiver - Manual (Page 52)

53
Troubleshooting
W hen in dou bt !
Many issues can be resolved by powering the unit off and then back on again or by
resetting to factory default settings. Before proceeding to any other troubleshooting
procedure follow these steps:
1. Set power to OFF
2. W ait 10 second s or until display completely blanks
3. Set p ower to R EC EIV E or T RA NS MIT
Reset to Default Factory Settings
1. Set power switch to OFF
2. Press and hold C key
3. Continue to hold C and s et the pow er sw itch to either R EC EIV E or T RA NS MIT
4. Releas e C key when CLEA R/R ES ET mess age appears
Default factory settings are as follows:
Ch annel 17 Display Contrast Medium
T rans mitter
Zones A B C D L all
enabled D e lay T im e 0.01 00 s ec
Receiver Zone A Equalize
C a lc u lat ed T im e 0.15 00 s ec
Relay Mode OFF I nt er val T im e 100 sec
Operating mode N O R M A L M u lt ip op T im e 1.00 sec
C o nt ac t T im e 0.12 sec Counter Mode OFF
Beep Mode All Cou nter Load 36
Fast Mode OFF
N
T he following indic ators m ay operate erratically durin g res et, but w ill return to
norm al operation wh en res et com pletes: B attery Level, Frequ enc y Lock , Beep Mod e,
and C han nel.
L
The CLEA R/RES ET m essage also displays the software version installed in the
unit. T o view just th e sof tware vers ion withou t losing setting s ref er to the Software
Version Display section, Page 40, for more information.