MicroNet Technology SP755D - Manual (Page 16)

11
2. Hardware Installation
Unpack the print server package and verify that all the items listed in the
section 1.2 are provided.
Connect the print server to the printer you want to share on the network.
Connect the print server to your network by attached the network cable to
the UTP port of the print server.
Connect the power adapter to the print server. The print server will
perform the Power-On-Self-Test (POST) after it is powered on. During the
POST, the Status and Ready LEDs will be on. When the LEDs are
unlighted, the print server is ready.
NOTE1: MUST use the power adapter shipped with the print server, do
NOT use any other power adapter from any sources.
NOTE2: To prevent the compatibility problem between print server and a
few printer, it is recommended that you power on the print server before
the printer.