MicroNet Technology SP755D - Manual (Page 80)

75
8.4.2 TCP/IP
You can configure the print server to automatically get IP from DHCP
server or manually specify static IP. The print server also has a built-in
DHCP server. You can enable this DHCP server and let it manages IP for
you.
If you need the print server to automatically get an IP from DHCP server,
select “Enable Obtain TCP/IP Settings Automatically (Use DHCP/
BOOTP)”. You also can select “Disable Use the following TCP/IP
Settings” to manually assign “IP Address”, “Subnet Mask” and
“Gateway” for the print server.
You can enable/disable or set auto for the print server’s DHCP server.
The DHCP server is disabled by default. If the DHCP Server is enabled or
set Auto, you have to assign a range of IP addresses here. Fill in the
“Start IP”, “Range”, “DNS”, “Subnet Mask” and “Gateway”, and the print
server will assign a unique IP for each client. Note that when “Auto” is
selected, the DHCP Server of the print server will be enabled only when
there is no other DHCP Server within the network.