MaxTech xpm56i V.42bis - Manual (Page 10)

9
&D1 Modem returns to Command Mode after DTR
toggle
&D2 Modem hangs up, returns to the Command
Mode after DTR toggle
&D3 Resets modem after DTR toggle
&F_ &F Recall factory default configuration
&G_ &G0 Guard tone disabled
&G1 550 Hz guard tone
&G2 1800 Hz guard tone
&M_ &M0 Asynchronous operation
&P_ &P0 United States setting for off-hook (make) -
to-on-hook (break) ratio
&P1 UK and Hong Kong off-hook (make)-to-on-
hook (break) ratio
&S_ &S0 Force DSR Signal High (ON)
&S1 DSR is off in command mode, on in on-line
mode
&T_ &T0 Ends test in progress
&T1 Perform Local Analog Loopback Test
&T3 Perform Local Digital Loopback Test
&T4 Grant Remote Digital Loopback Test
request by remote modem
&T5 Deny Remote Digital Loopback Test request
by remote modem
&T6 Perform a Remote Digital Loopback Test
&T7 Perform a Remote Digital Loopback Test and
Self-Test
&T8 Perform Local Analog Loopback Test and
Self-Test
&U_ &U0 Enable Trellis Coding @ V.32
&U1 Disable Trellis Coding @ V.32
&V_ &V0 Displays Active and Stored Profile 0
&V1 Displays Active and Stored Profile 1
&W_ &W0 Stores the active profile as Configuration
Profile 0
&W1 Stores the active profile as Configuration
Profile 1
&Y_ &Y0 Configuration Profile 0 active upon Power
on or reset
&Y1 Configuration Profile 1 active upon Power on
or reset