MaxTech xpm56i V.42bis - Manual (Page 18)

17
1. Make sure the correct modem type is selected in the Voice/
FAX software. Use “Cirrus Logic” or similar selection. Do
not select “Rockwell or Rockwell ICS” configuration.
Section Seven - Specifications
CCITT/Bell Std. V.42bis, V.42, V.32bis, V.32, V.29,
V.27ter, V.22bis, V.22, V.21, V.17,
Bell212/103
MNP protocols: MNP 5, 4, 3, 2
Host Interface: 8 bit PC bus
COM ports: 1, 2, 3, 4
IRQ lines: 2, 3, 4, 5
FAX Group: Group III Send/Receive Standard
FAX Command set: EIA/TIA-578 Service Class 1
Voice Command set: Cirrus Logic
Escape Detection:
TIES Escape Sequence
Transmit level: -12 dBm +/- 1 dB
Receiver Sensitivity: -40 dBm
UART:
16550 compatible
Data format: 300-57600 bps (8N1, 7E1,7E2,7O1,7O2)
Power: 0.75 W
Temperature: 0 to 55 degrees C (Operating); -20 to 80
degrees C (Non-operating)
Section Eight - Support and Service
In the unlikely event you experience difficulty in the use of this
product, we suggest you: (1) consult the Troubleshooting section
of this guide and (2) consult with your dealer. To obtain service for
this product, follow the Return Merchandise Authorization Proce-
dure as outlined in the Warranty card.
Section Nine - FCC , DOC & Other Notices
9.1 FCC Compliance
This equipment complies with Part 68 of the FCC Rules. On this
equipment is a label that contains, among other information, the
FCC registration number and Ringer Equivalence Number (REN)
for this equipment. You must, upon request, provide this informa-
tion to your telephone company.
If your telephone equipment causes harm to the telephone net-
work, the Telephone Company may discontinue your service
temporarily. If possible, they will notify in advance. But, if
advance notice isn’t practical, you will be notified as soon as