MaxTech xpm56i V.42bis - Manual (Page 29)

9
mode
&T_ &T0 Ends test in progress
&T1 Perform Local Analog Loopback Test
&T3 Perform Local Digital Loopback Test
&T4 Grant Remote Digital Loopback Test
request by remote modem
&T5 Deny Remote Digital Loopback Test request
by remote modem
&T6 Perform a Remote Digital Loopback Test
&T7 Perform a Remote Digital Loopback Test and
Self-Test
&T8 Perform Local Analog Loopback Test and
Self-Test
&U_ &U0 Enable Trellis Coding @ V.32
&U1 Disable Trellis Coding @ V.32
&V_ &V0 Displays Active and Stored Profile 0
&V1 Displays Active and Stored Profile 1
&W_ &W0 Stores the active profile as Configuration
Profile 0
&W1 Stores the active profile as Configuration
Profile 1
&Y_ &Y0 Configuration Profile 0 active upon Power
on or reset
&Y1 Configuration Profile 1 active upon Power on
or reset
&Zn=x n=0-3 Store telephone number x into non-volatile
RAM
%E_ %E0 V.22bis auto-retrain disabled
%E1 V.22bis auto-retrain enabled
%G_ %G0 Enable Auto Fall Forward/Back
%G1
Disable Auto Fall Forward/Back
3.5 MNP/V.42/V.42bis Commands
%An n=0- Set auto-reliable fallback character to n (where
127 n = 0 to 127,ASCII). Requires the \C2 setting
%C_ %C0 Disable MNP Class 5 data compression
%C1 Enable MNP Class 5 data compression
\A_ \A0 64-character maximum MNP block size
\A1 128-character maximum MNP block size
\A2 192-character maximum MNP block size
\A3 256-character maximum MNP block size