Mr. Heater SRPH02S - Manual (Page 14)

14
MAINTENANCE/CLEANING/STORAGE
CLEANING :
1.Remove the reflector and emitter by removing the 4 screws
that fasten the emitter to the lower screen cone .
Any debris in the
burner port should be cleared. Any rust can be
removed carefully with a wire brush. Never use a piece of wood,
or other materials that might break off and block the ports.
2.Remove lower cone cylinder by removing the 4 screws which
attach the lower cone cylinder to the control cylinder. Clear
debris on the surface of
thermocouple.
3.Remove the 4 screws at the bottom of control cylinder. Clear
the debris of the surface and the inside of the
injection nozzle.
It is recommended that the painted components from the emitter
down are periodically protected with a coat of automobile wax. If
repainting is necessary, paint only the post and gas cylinder
housing. Never paint the reflector, head assembly, or instruction
plate on post.
NOTE :
Keep exterior surfaces clean:
Use warm soapy water for cleaning. Never use flammable or
corrosive cleaning agents. While washing your unit, be sure to
keep the area around the combustion assembly dry at all times. If
the gas control is exposed to water in any way, DO NOT try to use it.
It must be replaced.
MAINTENANCE :
To enjoy years of outstanding performance from your heater make
sure you perform the following maintenance activities on a regular
basis:
Keep exterior surfaces clean.
Use warm soapy water for cleaning. Never use flammable or
corrosive cleaning agents.
While washing your unit, be sure to keep the area around the
burner and pilot assembly dry at all times. If the gas control is
exposed to water in any way, DO NOT try to use it. It must be
replaced.
Air flow must be unobstructed. Keep controls, burner and
circulating air passageways clean. Signs of possible blockage
include:
Gas odor with extreme yellow tipping of flame.
Heater does NOT reach the desired temperature.
Heater makes popping noises.
Heater glow is excessively uneven.
Spiders and insects can nest in burner or orifices. This
dangerous condition can damage heater and render it unsafe for
use. Clean burner holes by using a heavy-duty pipe cleaner.
Compressed air may help clear away smaller particles.
Carbon deposits may create a fire hazard. Clean dome and
emitter with warm soapy water if any carbon deposits develop.
WARNING
DO NOT touch or move heater for at least 45 minutes after
use. Allow all burner elements to cool before touching.
FOR YOUR SAFETY :
NOTE: In a salt-air environment, such as near an ocean,
corrosion occurs more quickly than normal. Frequently
check for corroded areas and repair them promptly.
NOTE: Wait until heater is cool before covering.
STORAGE :
Between uses:
During periods of extended inactivity or when transporting:
Turn the control knob to "OFF" position.
Turn LP cylinder to "OFF" position.
Store heater upright in an area sheltered from direct contact
with inclement weather (such as rain, sleet, hail, snow, dust
and debris).
If desired, cover heater to protect exterior surfaces and to
help prevent debris in air passages.
Turn the control knob to "OFF" position.
Disconnect LP Cylinder and move to a secure, well-ventilated
location outdoors.
Do NOT store in a location that will exceed
125 degrees F.
The propane cylinder must be stored outdoors in well-ventilated
area, and it must be out of reach of children, and not in a building,
garage or any other enclosed area.
Store heater upright in an area sheltered from direct contact with
inclement weather (such as rain, sleet, hail, snow, dust and
debris). If desired, cover heater to protect exterior surfaces and
to help prevent debris in air passages.
Yellow Tip
Primarily Blue Flame
Visually check
Emitter Screen