Mr. Heater SRPH02S - Manual (Page 9)

9
ASSEMBLY
Step 7
Step 8
NOTE: Assembly of this heater requires
basic mechanical skills. Proper assembly
is the responsibility of the installer.
Step 7 ---- Connect Gas Line to Cylinder
Step 8 ---- Check for leaks
Attach Gas hose to regulator with 3/8 inch open end
wrench and adjustable wrench.
Attach regulator to cylinder. Tighten securely.
Move cylinder to the plate of base assembly.
Your Patio Heater has been checked at all
factory connections for leaks. To check the
connection of the gas hose/regulator/cylinder:
1) Make leak solution by mixing 1 part liquid
dish soap and 3 parts water.
2) Brush several drops (or use spray bottle)
of the solution onto the gas hose/regulator and
regulator/cylinder connection.
3) Turn on gas. Inspect the connections and look
for bubbles.
4) If no bubbles appear, the connection is safe.
5) If bubbles appear, there is a leak, loosen and
re-tighten this connection.