MITSUBISHI ELECTRIC DX-TL4U - Manual (Page 59)

Four-Channel Digital Video Recorder
49
Figure 66 — Port Number Setup screen.
NOTE: You will need to get the appropriate Port Number for each DX-PC4U (Remote
Operation Software) related program (Admin, Watch, Search and Callback) from your network
administrator.
Change the number by highlighting it and using the Up and Down arrow buttons to increase or
decrease the number.
The factory default Port settings are:
Remote
Admin: 8200
Remote Watch: 8016
Remote Search: 10019
Remote Callback: 8201
NOTE: The system restarts automatically after changing the port settings.
NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR
cannot be connected with a PC running RAS.
CAUTION: When changing the port settings, you must change the port settings on
a PC running DX-PC4U as well. Refer to the DX-PC4U manual for details.
You can save your changes and return to the Network Setup screen by highlighting OK and
pressing the button. Selecting Cancel exits the screen without saving the changes.
Selecting DHCP from the Type and highlighting OK reads the current IP Address of the DVR
configured by DHCP (Dynamic Host Configuration Protocol) network.