Mercedes-Benz CS1000 User Manual
Page 108
) 2
) 2
) 2
) 2
108
FAULT DIAGNOSIS
1. IGNITION : Position 1
2. Temperature selector wheel : "LO"
3. Within 20 seconds press the REST and DEFROST buttons simultaneously for more than 5 seconds.
4. The LED in the RECIRCULATE button flashes and "dI A" appears on the display.
5. Press the AUTO button until all DTC's are displayed and recorded.
6. The current faults are displayed first, then the intermittent faults. "END'" is displayed when all codes have
been displayed.
7. To erase codes press v and ^ simultaneously for more than 5 seconds. The display will then show "---".
Press AUTO to cancel the erase.
8. IGNITION : OFF to end the test program.
FAULT CODES - 202 Chassis from 9/95
DTC Readout
Description
026
CAN Bus Communication
226
In-Car Air Temperature Sensor (B10/4)
227
Outside Air Temperature Sensor (B14)
228
Heater Core Temperature Sensor (B10/1)
230
Evaporator Temperature Sensor (B10/6)
231
Engine Coolant Temperature Sensor (B11/4)
232
Refrigerant Pressure Sensor (B12)
233
Refrigerant Temperature Sensor (B12/1)
241
Refrigerant Level
416
Coolant Circulation Pump (A31m1)
417
Left Duovalve (Water Valve) (Y21y1)
418
Right Duovalve (Water Valve) (Y21y2)
419
A/C Compressor Electromagnetic Clutch (A9k1)
420
Closed (Idle) Throttle Speed Increase
421
Pulse Module (N65)
422
Serial Interface Connection (K1) to Instrument Cluster (IC)
451
Diverter Flap (Y11/3)
452
Blend Air Flap (Y11/3)
453
Fresh/Recirculated Air Flap (Y11/3) Long Stroke
454
Fresh/Recirculated Air Flap (Y11/3) Short Stroke
455
Defroster Outlet Flap (Y11/3) Long Stroke
456
Defroster Outlet Flap (Y11/3) Short Stroke
457
Footwell Flap (Y11/3) Long Stroke
458
Footwell Flap (Y11/3) Short Stroke
459
Serial Interface Connection (K2) to Instrument Cluster (IC)