Mercedes-Benz CS1000 - Manual (Page 44)

1
ANALOG CODES
CS1000 Code Scanner OB15-11
44
#(# '

#(# '

#(# '

#(# '

Model Model Years
124.051 1990-1995
129.061 129.066 1990-1995
Connect wires of Scanner as follows:
Scanner Data Link Connector 16-pin
Yellow Socket 8
Black Socket 1
Red Socket 16
FAULT CODE TABLE
DTC Readout Possible Cause of Failure
1 No fault found
2 Maximum retard setting on at least one cylinder has been reached
3 Engine coolant temperature sensor faulty
4 Load sensor in EAL/AKR control module faulty
5 Knock sensors 1 and/or 2 faulty
6 Camshaft position sensor faulty
7 Knock output switch in EAL/AKR ignition control module faulty
8 Transmission overload switch does not close
9 Transmission overload switch does not open
10 Data exchange from EAL/AKR engine control module to CFI control module faulty.
11 Preference resistor faulty
12 Tn-signal is outside the tolerance range
13 Full load contact does not open.
14 Idle speed contact does not open.
15 Ignition coil 1 output from EAL/AKR ignition control module faulty
16 Ignition coil 2 output from EAL/AKR ignition control module faulty
17 Crankshaft position sensor faulty