Mercedes-Benz CS1000 - Manual (Page 37)

1
ANALOG CODES
CS1000 Code Scanner OB15-11
37
!' &

!' &

!' &

!' &

Models Model Years
140.057 140.076 1992-1995
Connect wires of Scanner as follows
Scanner Data Link Connector 38-pin
Yellow Socket 19
Black Socket 1
Red Socket 3
FAULT CODE TABLE
DTC Readout Possible Cause of Failure
1 No fault found
2 Right oxygen sensor faulty
3 Lambda control of right LH-SFI control module faulty
4 Air injection at right cylinder bank faulty
5 Exhaust gas recirculation of right LH-SFI control module faulty
6 Idle speed control faulty
7 Ignition system for right cylinder faulty
8 Right engine coolant temperature sensor, circuit open or circuit short
9 Right intake air temperature sensor, circuit open or circuit short
10 Voltage at mass air sensor too high/low
11 Tn-signal (rpm signal ) at right LH-SFI control module faulty
12 Oxygen sensor heater of right oxygen sensor, circuit open or circuit short
13 Camshaft position sensor signal of right ignition control module faulty
14 Intake manifold pressure at startup (in right ignition control module) too low or too
high
15 Wide open throttle position information faulty
16 Closed throttle position information faulty
17 Data exchange fault between right-hand control modules LH-SFI ignition control
module electronic accelerator
18 Right adjustable camshaft timing solenoid circuit open or circuit short