Motorola ML910 - Manual (Page 110)

5-16 BIOS Setup Utility & MLUA
Read From EC
To read configuration parameters from the EC:
1. Click on the Read From EC button on the left pane of the window.
2. Wait while the MLAA is communicating with the EC.
After a few seconds, the MLAA will display the data read from the EC.
Read From File
To read configuration parameters from a file:
1. Click on the Read From File button on the left pane of the window.
2. In the Open window, navigate to the drive and folder where the configuration
data file is located.
3. Double-click on the desired file, or highlight the file and click the Open button.
Parameters from the configuration data file are retrieved and displayed in the application
window.
Note:
ƒ The manufacturer’s default configuration data file is saved as Default.csv file.
ƒ The application will only open valid configuration data file with *.csv file
extension.
ƒ If you wish to use the settings from configuration data file, you need to click on
Write To EC button to apply the changes.
Write To EC
To write configuration parameters to the EC:
1. Click on the Write To EC button on the left pane of the window.
2. Wait while application is writing to EC.
After a few seconds, the message “System EC configuration updated successfully” is
displayed if operation is completed successfully.
Save To File
To save configuration parameters to a file:
1. Click on the Save To File button on the left pane of the window.
2. In the Save As window, navigate to the drive and folder where you want to save
the configuration data file.
3. Type a file name for the configuration data file, then click the Save button.
Existing configuration parameters are saved.