Maretron MBB100 - Manual (Page 11)

® ®
2.4.4 USB Device Connection
There are four external USB 2.0 connectors. To connect a USB 2.0 or USB 1.1 device, please follow
the instructions below.
Step 1:
The locations of the USB connectors are shown in and Figure 5.
Step 2: Align the USB device connector with one of the connectors (see Figure 7).
Figure 7 – USB Device Connection
Step 3: Once aligned, gently insert the USB device connector into the MBB100 connector.
2.4.5 Power Connection
The MBB100 can be connected to a power source in one of two ways (over current protection should
be provided and should be sized in accordance with ABYC E-11, AC and DC ELECTRICAL
SYSTEMS ON BOATS);
1) Directly with 9-32VDC power source using the green power terminal block found on the rear panel
of the MBB100 (see Figure 8).
a) Connect the power source negative terminal to the right hand terminal,
b) Connect the power source positive terminal to the center terminal.
Figure 8 - MBB100 Power Terminal Block
2) Indirectly with 100-240VAC 47-63Hz power source using the AC power adapter and the AC power
cord supplied in the box.
a) Connect the AC power cord to the AC power adapter,
b) Connect the AC power cord to the AC power outlet,
Revision 1.0 Page 7