Maretron MBB100 - Manual (Page 15)

® ®
2.5.2 Entering N2KServer
®
or IPG100 Connection Information
Once the MBB100 has been properly configured to connect to your LAN, you must configure the
connection to enable the MBB100 to receive information from an instance of N2KServer
®
or an
IPG100 Server. This is done through the following steps:
Figure 12 – N2KView
®
Window with Tabs Displayed
a. Click anywhere inside the N2KView
®
screen to display the screen tabs as shown in Figure 12
above.
b.
Click on the “Connections” tab on the right side of the N2KView
®
screen to display the
Connections Settings dialog.
Revision 1.0 Page 11