Motorola MTP810 EX - Manual (Page 39)

5 - 6 TEST SETUP & TESTING
For IFR 2968, perform the following steps to configure the unit with the radio set:
1. Turn ON the IFR.
2. Press “Systems” Mode Key (wait until the digital system is initialized).
3. Press “Tetra Mobile” soft key.
4. Press “Setup” soft key and enter the System Parameters Screen.
5. Press “Channel Plan” soft key.
6. Press “Tetra 380+0MS” soft key for MTP810 Ex. The “Control Channel”
automatically changes to “3600”; and “Traffic Channel” automatically
changes to 3700.
7. Press twice the “Traffic Channel” soft key and check that the marker goes to
Timeslot. Press Data key “3” followed by the “Traffic Channel” soft key, to
change to Timeslot “3”.
8. Press “Country Code” soft key. Enter “234” and press again “Country Code”
soft key.
9. Press “Network Code” soft key. Thereafter, enter “2392” and press “Network
Code” soft key.
10. Press “Base Color” soft key. Thereafter, enter “1” and press “Base Color” soft
key.
11. Press “More” soft key.
12. Press “Location Area” soft key. Thereafter, enter “22” and press “Location
Area” soft key.
13. Press “More” soft key.
14. Press “Min Rx Level” soft key. Thereafter, enter “-110dBm” and press “Min Rx
Level” soft key.
15. Press “Max Tx Level” soft key. Thereafter, enter “30dBm” and press “Max Tx
Level” soft key.
16. Press “Access Parameter” soft key. Thereafter, enter “-53dBm” and press
“Access Parameter” soft key. Press “Test Mode” soft key and press
“Enabled”.
17. Press “Base Service” soft key.
Note: You are entering base services setup.
The displayed values are factory defaults and should not be changed.
Power On Registration: required
Power Off Deregistration: required
Priority Cell: yes
Minimum Mode Service: may be used
Migration: supported