Millennium Enterprises Stereo150 - Manual (Page 15)

The Rear Panel
1) Fuse- 100, 120 VAC 6 Amp fuse is inserted here.
2) Expression Pedal 1 and 2 jacks - This is the insert point for an external expression pedal. Standard volume or voltage controller pedals
can be used in these inserts. Once inserted, this expression pedal can be linked to control any parameter of the Millennium. For more
about assigning expression pedals, see pg. 57.
Notice: When using the Millennium with the Johnson Amplification J-12 foot controller, the 1/4 Expression Pedal inputs on the rear of the
unit are referred to as EXP 3 and EXP4. When the Millennium is used alone, the Expression Pedal Inputs are referred to as EXP 1 and EXP 2.
3) MIDI IN - The MIDI IN port allows the Millennium to respond to incoming MIDI information.
4) MIDI OUT/THRU - This port allows the Millennium to send out or pass MIDI data to other devices.
5) J-3 Footswitch jack - This is the insert point for the J-3 Multi-function footswitch.
6) Johnson Amplification J-12 Foot Controller Input - This is a 5-pin DIN plug for connecting the optional Johnson Amplification J-12 foot
controller. Connection of the J-12 should be made before the Millennium is turned on.
IMPORTANT: CONNECTING A DEVICE OTHER THAN THE J-12 OR CONTROL ONE CAN DAMAGE THE UNIT.
7) Left and Right Extension Speaker outputs - These 4 outputs are used to connect additional speaker cabinets. Up to 4 extension speaker
cabinets can be connected to the Millennium. Make sure that the extension cabinet being connected has at least a 4 ohm load resistance
per channel. The ohm load resistance effects how much power the extension cabinet receives from the Millennium.
8) Direct XLR outputs - These XLR outputs are used for recording direct or for sending the output signal to a live mixing console. When
using the XLR outputs, the speakers within the amplifier can be disconnected.
9) Loop Return Jack - This is the effects loop mono return jack. Connect the output of an external effect device here.
10) Loop Send Jack - This is the effects loop send jack.
1 2 3 4 5 6 7 8 9 10
J12
Expression Pedal
1 2 In
MIDI
Out/Thru
Speaker Output (4 Ohms Minimium)
Left Speaker
Right
FX Return FX Send
Direct/Record
Output
Left
Right Speaker
J3
Footswitch
Johnson Millennium
User Guide
Section -1 Introduction
7