Miller Electric Renegade 180 - Manual (Page 17)

.
Complete Parts List available at www. MillerWelds.com
OM-228 042 Page 13
4-3. Gun Specifications
Air-Cooled Welding Guns For GMAW And FCAW Welding
.
Using gasless flux cored wire reduces gun duty cycle.
Ref. 800 797-D
M-15 Feeds .023 To .045 in. (0.6 To 1.1 mm) Hard Or Flux Cored Wires
.045 in. (1.1 mm) wire requires liner change to MILLER Part No. 194012 in addition to contact tip change
Duty Cycle Rating:
100%: 150 A With CO
2
Shielding Gas; 120 A With Mixed Gases
60%: 200 A With CO
2
Shielding Gas; 150 A With Mixed Gases
Weight With 15 ft (4.6 m) Power Cable: 6.0 lb (2.7 kg)
Identified With zz On Power Cable
4-4. Dimensions, Weights, And Operating Angles
Dimensions
Height 31 in (787 mm)
Width 32 in (813 mm)
D
Length 41 in (1041 mm)
D
A 31-5/8 in (803 mm)
B
Do not exceed tilt angles or engine
B 10-9/16 in (268 mm)
B
Do not exceed tilt angles or engine
could be damaged or unit could tip.
D t
t it h
C 13-25/64 in (340 mm)
Do not move or operate unit where
it could tip.
D 22-3/4 in (577 mm)
it could tip.
E 1-9/16 in (40 mm) A
F 19-5/8 in (498 mm) C
G 13/32 in (10 mm) Dia.
Weight
275 lb (125 kg) Recoil Start
307 lb (140 kg) Electric Start
4
G
15 °
15 °
15 °
15 °
Optional Lifting Eye
Weight Rating
4
Holes
15 °
15
F
E
430 lb (195 kg)
NOTICE − Optional lifting eye may not
be installed on units with optional cylin-
der rack.
803 403 Engine End
E
804 476-C
DC Amperage
DC V
oltage
0
0
20 40 60 80 100 120 140 160 180 200
5
10
15
20
25
30
35
40
4-5. Volt-Ampere Curves
233 243
This welding power source can be
powered by the unit engine or utility
power via a wall receptacle.
The volt-ampere curve shows the
minimum and maximum voltage
and amperage output capabilities of
the unit. Curves of all other settings
fall between the curves shown.
Wall Maximum
Wall Minimum
Generator
Maximum