MITSUBISHI ELECTRIC HS-U748 - Manual (Page 51)

49
OUT
AUDIO
L
R
ANTENNA
OUT
IN
VIDEO
R
L/MONO
TIMER
RESET
OUT
IN 1
IN 1
S-VIDEO
OUT IN 1
Rear Panel Jacks
AUDIO INput and OUTput jacks
Red and white jacks for receiving (IN) and sending
(OUT) audio signals. Red signifies the right
channel, and white signifies the left channel.
Stereo audio cables are also color coded red and
white. If you are receiving or sending a mono
(non-stereo) signal, you should use only the left
(white) terminal.
VIDEO INput and OUTput jacks
Yellow jacks for receiving (IN) and sending (OUT)
video signals to a monitor TV or from another
VCR. The black jacks marked with “S-VIDEO”
can be used to connect televisions with S-Video
jacks. (“S-Video jack” refers to a Separated
Luminance-Chrominance (Y/C) jacks that
conforms to the NTSC signal.) TIMER RESET
Erases all programmed recording settings and
resets the clock. Use this button with care.
ANTENNA IN jack
Attach an external antenna or cable to bring in an
outside signal.
ANTENNA OUT jack
Attach a coaxial cable to your TV to send out
antenna/cable signals from the VCR to your TV.
POWER light : PWR.
Is lit when power is ON.
VCR light : VCR
Indicates that the picture is controlled by the VCR.
Cassette light :
Lights up when a tape is in the VCR.
time display
This area displays:
• current time
• OTR and OTR
2 timer
VCR
REC
PM
PWR.
Front Panel Display
Location of Controls
Record light : REC
Lights up when the VCR is recording.
Flashes when the VCR is in recording pause
mode.
Programmed recording light :
Lights up when VCR is off and it is programmed to
record.
PM light : PM
Lights up when the current time or start time of
OTR
2 is in the afternoon.
Turns off when it is in the morning.