MITSUBISHI ELECTRIC HS-U748 - Manual (Page 53)

51
Trouble Checks
If your VCR malfunctions, try the following steps prior to contacting your Mitsubishi Dealer:
1 Check the Trouble Checks below to see if there is a solution to the current problem that you are
experiencing.
2 If the problem is not addressed on the Trouble Checks, the safety circuits in the VCR may be in
operation, thus please try the following: (the clock setting and the timer recording will be deleted.)
1 If possible, press EJECT on the front panel and remove the tape.
2 Press TIMER RESET on the rear panel with a pencil or a ball point pen.
3 If a tape is not loaded, press POWER to turn the power on. If a tape is loaded, wait about 1 minute
until the tape protecting function is completed, then press POWER.
3 You may also try the following procedure if the above steps did not resolve the problem (All settings will
be reset to the default settings.).
1 Press POWER on the front panel continuously for about 8 seconds until the current time display on
the front panel shows “- : - -.”
2 If a tape is not loaded, press POWER to turn the power on. If a tape is loaded, the tape protecting
function will work and “99” will appear on the front panel display to begin count down. Wait about 1
minute until it reaches “00” to show the tape protecting function is completed, then press POWER.
If the problem with your VCR persists, contact your Mitsubishi dealer for assistance.
Problem
The VCR won’t turn on.
The VCR power is on but no
controls work.
You can’t see the VCR’s picture
on your TV.
Poor picture when watching the
VCR’s tuner on your TV.
VCR REC button doesn’t
function.
No picture during recording.
VCR does not record TV
program.
Try This...
• Check the power cord and the AC outlet.
• Is the child lock in use? If so, press and hold DISPLAY on the remote
for more than 8 seconds until the LOC display turns off.
• Is the child lock in use? If so, press and hold DISPLAY on the remote
for more than 8 seconds until the LOC display turns off.
• Set the VCR/TV slide switch to VCR position.
• Press TIMER RESET on the rear panel.
• Check the TV’s input setting.
• Check to see that your VCR is not set to External L1 or External L2.
• Check to see if your TV is set to the correct channel or input.
• Check your TV’s fine tuning, if using an older TV.
• Check your connections to make sure they are secure.
• Check the erasure prevention tab on the tape cassette.
• Check the hook-up.
• Check to see if your TV is set to the correct channel or input.
• Check the VCR tuning.
• Check the input selection on the VCR. Does the channel display on
the TV screen show External L1 or External L2? If so, switch it to
tuner by pressing INPUT.