MITSUBISHI ELECTRIC WD-52527 - Manual (Page 42)

2
Chapter 3. NetCommand Setup and Editing
Review Screen
Figure 5
After you have made your device choices the Review
Screen will display. It is important to review the settings
to ensure that they are correct. If necessary, you can
use
<Back to return to the Device Setup screen to make
changes.
Figure 5. Review screen
Finish Screen
Figure 6
To complete the NetCommand setup, select Finish
from the Finish screen.
If you wish to change any of the pre- configured
inputs or names for the devices, or add devices not in
the pre-configured setup, select
Edit to display Edit
NetCommand menu.
If your A/V receiver was not listed, select Edit to add
the AVR and then assign all devices to new AVR inputs.
Figure 6. Finish screen
It is still necessary to memorize the available channels
for Antenna-1 (and Antenna-2, if used). You may do
that by going to the TV Main menu and selecting
Antenna. Instructions to memorize channels are found
in the Antenna menu section.
Note: The Review screen lists the TV input and A/V
receiver input used with each device. You must
correctly identify the inputs you used when you
connected the devices. If you have not connected
your devices, write down these inputs as a guide. If
you cannot use these inputs, or if you would like to
change the name of a device, use the instructions in
Edit NetCommand to make necessary changes.
Note: If you select Next> on the Review screen, all
selections made are finalized.
On the Review screen, adding or deleting check marks
will turn the adjacent devices or inputs On or Off. 1394
device names only appear on the Review screen when
the devices are connected to the TV.
NetCommand ® Initial Setup, continued