Philips Magnavox MVR630MG - Manual (Page 7)

CH 4
or
CH 3
CH3 / CH4
Switch
CH3 CH4
75
ANT /
CABLE
75 Ω ANT / CABLE
RF coaxial cable
3 Connect the supplied black RF coaxial cable to the OUT Jack on the back
of the VCR and to the ANTENNA IN Jack on the TV. (You may use either a
snap-on type (supplied) or screw-on type of coaxial cable, whichever you prefer.)
The ANTENNA IN jack on your TV may be labelled 75 ohm or RF In instead.
Check your TV owner’s manual for details.
5 Set the CH3/CH4 switch on the back of the VCR to CH3 or CH4, whichever
channel is not used or least used in your area.
Set the TV to the same channel.
For example, when playing a tape, if the CH3/CH4 switch is set to CH3, the TV
should be on channel 03.
Hookups Without a Cable Box/Direct Broadcast System (cont’d) 7
ANTENNA IN Jack
(on back of TV)
example only
4 Plug in the power cords of the TV and the VCR.
6 You are ready to turn on the VCR. Please go to page 11 before turning on
the VCR.
mvr630mg.QX33 2/11/02 12:05 PM Page 7