Cablelink 75 transmitter, Cablelink 75 receiver – Marmitek 20041 User Manual
Page 4
3. CableLink 75 Transmitter.
To operate the transmitter please use following items supplied:
1 CableLink 75 VideoTransmitter
1 Powersupply
1 RCA/RCA cable
1 Scart adaptor indicated "transmitter"
1 Infrared extender with 3 IR LED’s
1 Coaxial splitter
1 Coaxial cable
3.1 Control Elements, Transmitter.
1.
433MHz antenna: Receives the RF signals from the IR extender built in the CableLink
receiver. This allows you to operate your equipment (VCR, DVD player, etc) with your
original remote or supplied remote from the location where the CableLink Receiver is
used (e.g. at your remote TV). The antenna must be placed in an upward position.
2.
Input jack: for the infrared extender IR LED’s. Please note 5.2 for more information)
3.
Antenna Input (Cable In): To connect the CableLink transmitter to the Antenna wall
output (antenna of cable signal). Use antenna cable provided.
4.
Audio/Video input: Input for Audio and Video signals from your DVD player, VCR, etc.
5.
Audio/Video output: Signal available at the output is either the antenna signal
transmitted (if transmitter is in "Cable" mode) or signal connected to the Audio/Video
input [4]. (mode selected by the remote control: "CATV/AV")
6.
Power input: The supplied mains adaptor is connected to this input jack.
7.
Power ON/OFF: This is for switching the transmitter on and off. When switched on the
LED [13] will light up.
8.
2,4 GHz Antenna. Transmits the audio/video signals to the Receiver.
9.
Channel Selector: To set the 2,4GHz channel. Setting of Transmitter and Receiver should
be same (A,B,C or D)
10. Source: To select between Antenna input [3] or external connected equipment [4]
11. Cable Channel Down: Channel selection of the programmed TV Channels.
12. Cable Channel Up: Channel selection of the programmed TV Channels.
13. LED Indicator: lights when unit is switched on [7].
4. CableLink 75 Receiver
To operate the Receiver please use following items supplied:
1 CableLink Receiver
1 Powersupply
1 RCA/RCA cable
1 Scart adaptor indicated "Receiver"
4.1 Control Elements Receiver.
1.
433MHz antenna: Sends the RF signals from the IR extender built in the CableLink
4
MARMITEK