Memorex MVUC821 - Manual (Page 24)

23
SETTING THE DTV MENUS (CONTINUED)
This unit is equipped with a channel memory feature which allows channels to skip up or down to the next channels set into
memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the unit’s memory.
FAQs:
How many channels will I actually receive?
The actual number of channels that can be received depends on how many channels your satellite company, or local
area, provides. Contact your company to determine the number of channels in your area.
With the power on and the DTV mode selected, press the
SETUP button 1; the menu will appear. Press the
Navigation π 2 and/or † 3 button to select the Channel
menu.
1
3
1
2
Press the ENTER/Play/Pause (®p) button 1 to enter the
Channel menu. Press the Navigation π 2 and/or † 3
button to select the AUTO PROGRAM option, then press
the ENTER/Play/Pause (®p) button 1 again.
2
Select OK by pressing the ENTER/Play/Pause (®p) button
to start the Auto Programming. The unit will automatically
cycle through all the ATSC channels and store active
channels into memory. When Auto Scan is complete, the
lowest memorized channel will be displayed.
3
To stop Auto Scan before it is finished, press the
ZOOM/EXIT button; the lowest memorized channel (ATSC)
will be displayed.
4
SETTING CHANNELS INTO MEMORY
NOTE:
• Make sure that the antenna is connected properly before plugging in the AC power cord, turning on the unit and
accessing the Channel menu.
• In step 3, Select CANCEL to cancel the auto programming.
3
2
1