Memorex MVUC821 - Manual (Page 33)

32
DTV OPERATION
Adjust the volume level by pressing the VOLUME Up 1 or
Down 2 button.
1
2
3
1
3
4
5
2
4
Press the DTV button on the remote to select the DTV
option. Make sure the channels have been set into memory,
see page 23.
NOTE: You can also press the SOURCE button on the main
unit until the display shows ATSC to select the DTV mode.
Press the CLOCK button to show the time in the display and
press again to show ATSC.
2
Press the Power button to turn the unit on; the STANDBY
indicator will turn off.
1
For proper operation, before selecting channels, they must
be set into the unit’s program memory, see page 23.
Press and release the Channel Up/Skip (n) button 1 or
Channel Down/Skip (o) button 2. The TV automatically
stops at the next channel set into memory.
ATSC Direct Channel Selection buttons (0-9) 3
Use these buttons to select a channel. The channel number
will appear at the top right corner of the screen. Enter the
main channel number, then the - button 4, then enter the
sub-channel, followed by the ENTER/Play/Pause (®p)
button 5.