Motorola 3460 Fast'R - Manual (Page 71)

3460 Fast’R
C-7
+FCS= Sets negotiated T.30 parameters for session.
VR, BR,
WD, LN,
DF, EC,
BF, ST See Table 2-8
+FLI= a Defines local ID string a for TSI/CSI signals. Sent to
remote modem.
+FPI= a Defines local polling ID string a for CIG signals. Sent to
remote modem.
+FNR= r, t, i, n Controls the reporting of messages generated during
T.30 Phase B negotiations.
r - RX parameter messages
t - TX parameter messages
i - ID string messages
n - non-standard frame messages
For each sub-parameter, the options are:
0 Prevents reporting of messages
1 Reports messages
+FPS= n Contains value representing T.30 post page response;
includes page quality and end-of-page status
1 See Table 2-7
2 - 4 See Table 2-7
Table 2-2. Fax Class 2.0 AT Command Set (continued)
Command Option Description
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.