Monitor Audio EN 50082-1 - Manual (Page 6)

6
Installation - In-Wall Units
The CP Series In-Wall loudspeakers will provide long term satisfaction in terms of sound quality and reliability
provided they are installed correctly, according to the instructions and conditions contained in this manual.
Please read this installation guide carefully before proceeding. We assume the installer is trained and skilled in
the correct and safe use of hand and power tools, and has a working knowledge of local building and fire
regulations/codes as well as experience of the conditions/services behind walls and ceilings into which these
speakers will be installed.
IF IN DOUBT ABOUT YOUR ABILITY TO INSTALL THESE PRODUCTS SAFELY AND
CORRECTLY PLEASE CONTACT YOUR LOCAL AUTHORISED MONITOR AUDIO DEALER OR CUSTOM INSTALLER.
Parts List
PLEASE CHECK YOU HAVE THE FOLLOWING ITEMS IN THIS KIT BEFORE PROCEEDING:
•
1 x Complete speaker & tweeter assembly fitted to back box.
•
1 x Grille (which can be painted).
•
1 x Mounting cut out template (in packaging).
•
2 x Grille membrane (one for use during painting and the other as a clean replacement).
•
2 x Spare baffle mounting screws plus guarantee card in this manual.
WARNINGS:
•
A minimum depth of 98mm (4 Inches) is required for the back box to fit into wall/ceiling recess.
•
The fixing clamps require a minimum of 25mm (1 Inch) of surface area around the cut-out hole to ensure
a secure fixing!
•
The fixing clamps will operate on walls with a minimum thickness of 9mm (3/8 Inches) to a maximum
depth of 32mm (1¼ Inches).
•
Do not attempt to fix these speakers to your wall if you are unsure of your ability to provide a secure and
safe fixing.
IF IN DOUBT CONTACT YOUR LOCAL AUTHORISED MONITOR AUDIO DEALER.
•
Ensure that there are no water pipes, air ducts or electricity cables running immediately behind the cut
out area!
•
Please work from secure steps or scaffold and avoid trailing wires for your safety and those around you.
•
Always turn off the amplifier or other devices in the system when connecting these speakers.
Procedure
1. Secure template in position. Please note that the outer profile indicates size of cut-out. Fig 3. The
adhesive backing allows for repositioning a number of times.
2. Cut hole and Locate speaker cable and connect as shown below Fig 4.
3. Fit back box into prepared hole and tighten fixing clamps. These will move outwards on tightening! DO
NOT OVERTIGHTEN! Once contact is made 2-3 turns are all that is required.
4. Paint at a time to suit. Use paint masks (membrane) supplied and replace with new item supplied.
5. TO FINE-TUNE THE SPEAKERS PLEASE REFER TO PAGE 6.
Hole size to be cut
387 x 234mm
(15 1/4” x 9 3/16” )
Fig 3
In-wall template
Fig 4
Push down to fit cable
Black (Negative)
Red (Positive)
Position of 8
fixing clamps
Not to scale