Monitor Audio EN 50082-1 - Manual (Page 7)

7
Fine-tuning - In-Ceiling and In-wall speakers
The following adjustments can be made to your CP In-Ceiling and In-Wall loudspeakers as follows:
Adjusting H.F (High Frequency) control
(Silver CP and Gold CP models only)
The factory H.F setting provides a flat or 0dB level, which will suit the majority of typical installations.
However, it is possible to fine-tune the sound from the CP speakers to suit a room’s characteristics or
preferred listening tastes by using the following as a guide: -
a. Setting the switch in the +3dB position will add brightness and additional clarity to the system. This may
be effective in a room with a large amount of soft furnishings.
b. Setting the switch in the -3dB position will reduce the brightness on the system and provide a duller
sound. This may be effective in a room with a lack of soft furnishings, or in an installation with a wooden
floor.
Adjusting M.F (Mid-range Frequency) control
(Gold CP models only)
The factory M.F setting provides a flat or 0dB level, which will suit the majority of typical installations.
However, it is possible to fine-tune the sound from the Gold CP In-Ceiling and In-Wall speakers to suit a
room’s characteristics or preferred listening tastes by using the following as a guide: -
a. Setting the switch in the +3dB position will add presence and additional clarity to the system, particularly
in the vocal region. This may be effective for better resolution of dialogue and speech, or in an installation
where the listening position is a large distance from the speaker.
b. Setting the switch in the -3dB position will reduce the presence and the system will sound more ‘laid
back’. This may be effective where the speaker will be played for background music, or where the
listening position is situated close to the speaker.