Motion Computing M1400 - Manual (Page 54)

Chapter 4 Using Your Motion Tablet PC
Motion Computing M1400 Tablet PC User Guide 46
WARNING: When performing the following tasks, turn off your Tablet
PC, unplug the AC power connection, and remove the battery. Ground
yourself by touching a grounded conductive surface, such as a device
or appliance with a grounded, three-pronged plug. Avoid touching the
pins and leads on the memory module and the internal circuitry of the
Tablet PC.
1. After you disconnect power, unscrew
the L-shaped cover from the bottom of
the Tablet PC.
2. If you are replacing a module, pull the
clips on each side of the module to
release it. When it pops up, you can
easily remove it.
3. Align the pins on the memory
module with the receptors on the slot.
4. Gently push the new module into the slot at a
25-degree angle until it is firmly seated; then snap it down into place.
5. Replace the external cover and install the two screws.
I NSTALLING
O PTICAL D ISC
D RIVES
For information about installing your Optical Disc Drive, see the
documentation packaged with the drive.
Optical Disc Drive Software
CDROM Software — No special software drivers required to operate as a
standard CDROM device
DVD-ROM/CDRW Software — Requires CD writing software to write
onto a CDR/RW disc for CD authoring. While Windows XP Tablet PC
Edition 2005 software includes CD writing features and may be sufficient
for your needs, the additional CD writing software (provided with the drive)
contains advanced features beyond those offered by Windows XP. In
addition, you need to install the DVD software (also provided with the drive)
to view video DVDs.