Motion Computing M1400 - Manual (Page 67)

Chapter 4 Using Your Motion Tablet PC
Motion Computing M1400 Tablet PC User Guide 59
S ET U P A
D EVICE
(B LUETOOTH
M OUSE )
IMPORTANT: When installing Bluetooth devices, follow the steps in this
procedure before installing any software that came with the device. You may
need to install application software for the device at the end of this procedure
and should be prompted when this is necessary. However, do not install new
Bluetooth software for your Tablet PC.
Pre-Installation Step: Check the batteries
Before you begin the Bluetooth mouse installation, install new or fully-
charged batteries in the Bluetooth mouse.
1. Start the Bluetooth Application
a. Make sure that either the Bluetooth LED is flashing or that there is a
checkmark beside Enable Bluetooth Wireless radio (both indicate that
Bluetooth is running) in the Motion Dashboard.
b. Single tap the Bluetooth Devices icon in the system tray.
c. From the pop-up menu, select
Add a Bluetooth Device.
The Add Bluetooth Device
Wizard -Welcome window
appears.
2. Make the mouse discoverable
a. Before starting the Add Bluetooth Device Wizard, place the Bluetooth
mouse in discoverable mode. This sends a signal that is detected by the
Bluetooth card in the Tablet PC.
NOTE: Each Bluetooth mouse may have a different way to make it discoverable.
Some have a small “Connect” button on the back of the mouse. Look at the doc-
umentation that came with the Bluetooth device or visit the manufacturer’s web-
site for information.