Motion Computing M1400 - Manual (Page 86)

Chapter 4 Using Your Motion Tablet PC
Motion Computing M1400 Tablet PC User Guide 78
• Rub your fingers together to stimulate the natural skin oils so your fingerprint
is easier for the sensor to detect. Conversely, wipe your finger off so nothing
interferes with the scan.
• Clean the sensor. First, power down the Tablet PC and remove the battery.
Then, clean the sensor using a cotton swab sprayed with a window-type
cleaner (no bleach, solvents, or abrasives); then dry the sensor. Do not spray,
pour, or otherwise dispense any liquid directly on the sensor.
• Enroll a different finger. Some fingers have insufficient ridge information for a
successful enrollment.
NOTE: If the fingerprint capture times out, tap Back. This restarts the enrollment
process.
9. After OmniPass successfully cap-
tures three fingerprints, the Verify
Fingerprint window appears.
Swipe your finger one more time
to complete the enrollment.
When the messages “The selected
finger has been enrolled in
OmniPass” and “Successful Veri-
fication” and a green fingerprint
appear, enrollment is complete.
IMPORTANT: During the verification pro-
cess, you may get red fingerprint images or
the message “Verification Failed.” If this
happens, tap the Back button and try
again. You can have as many tries as you
need for enrollment and verification. If
needed, reread the section “Hints for Suc-
cessfully Enrolling a Fingerprint.”
10. Tap Next.
11. When you are prompted to enroll a sec-
ond fingerprint, tap Yes.
IMPORTANT: We recommend that you enroll a
second fingerprint. A finger injury could prevent
an authorization and block access to your ac-
counts.
12. Repeat Steps 7-10 to enroll a second fingerprint.