Installation and break-in procedures ... cont’d – Makita MAC2400 User Manual
Page 10
10
INSTALLATION AND BREAK-IN PROCEDURES
OWNERS MANUAL
MAKITA - MAC700 / MAC2400 / MAC5200
INSTALLATION AND BREAK-IN PROCEDURES ... Cont’d
CAUTION: Multi-Viscosity motor oils, like 10W30, should not be used in an air compressor. They
leave carbon deposits on critical components, thus reducing performance and compressor life.
Use air compressor oil only.
Initial Start Up Procedure:
Extension Cords:
To avoid voltage drop, power loss, and overheating of the motor, use extra air hose instead of an
extension cord. Low voltage can cause damage to the motor.
If an extension cord must be used:
Please see the chart below as the MINIMUM requirements:
Open the air receiver's drain valve.
Plug power supply cord into correct power source.
Run the compressor for a minimum of twenty (20) minutes in the no-load
condition to lubricate the bearings and pistons, and to seat the piston rings.
Close air receiver drain valve. Your compressor is now ready for use.
1)
2)
Use only an approved 3-wire extension cord that has a 3-blade grounding
plug and a 3-slot receptacle that will accept the plug on the air compressor.
Make sure the extension cord is in good condition.
3)
4)
Amp Rating
Length of cord in feet
(120 volts)
25’
50’
100’
150’
10 - 12
16
14
10
8
12 - 14
16
12
10
8
14 - 16
16
12
10
8
16 - 18
14
12
8
8
18 - 20
14
12
8
8