Makita MAC2400 - Manual (Page 11)

OPERATING PROCEDURES
11
OWNERS MANUAL
MAKITA - MAC700 / MAC2400 / MAC5200
INSTALLATION AND BREAK-IN PROCEDURES ... Cont’d
OPERATING PROCEDURES
Piping:
Plastic or PVC pipe is not designed for use with compressed air. Regardless of its indicated
pressure rating, plastic pipe can burst from air pressure. Use only metal pipe for air distribution
lines. If a pipe line is necessary, use pipe that is the same size, or larger than, the air tank outlet.
Piping that is too small will restrict the flow of air. If piping is over 100 feet long, use the next
larger size. Bury underground lines below the frost line and avoid pockets where condensation
can gather and freeze. Apply pressure before underground lines are covered to make sure all
pipe joints are free of leaks.
Grounding Instruction:
WARNING: Risk of electric shock!
In the event if a short circuit, grounding reduces the risk of shock by providing an escape wire
for the electric current. This air compressor must be properly grounded. The air compressor is
equipped with a cord having a grounding wire with an appropriate grounding plug. The plug must
be used with an outlet that has been installed and grounded in accordance with all local codes
and ordinances. The outlet must have the same configuration as the plug.
DO NOT USE AN ADAPTER.
Inspect the plug and cord before each use. Do not use if there are signs of damage.
DANGER: Improper grounding can result in electrical shock. Do not modify the plug that has
been provided. If it does not fit the available outlet, the correct outlet should be installed by a
qualified electrician.
Daily Start-Up Checklist:
Before attaching air hose or accessories, make sure the pressure switch lever
is set to “OFF” and the air regulator or shut-off valve is closed.
Attach hose and accessories. Too much air pressure causes a hazardous risk
of bursting. Check the manufacturer's maximum pressure rating for air tools
and accessories. The regulator outlet pressure must never exceed the
maximum pressure rating.
Turn the pressure switch lever to “ON/AUTO” and allow tank pressure to build.
Motor will stop when tank pressure reaches “cut-out” pressure.
Open the regulator by turning it clockwise. Adjust the regulator to the correct
pressure setting. Your compressor is ready for use.
Always operate the air compressor in well-ventilated areas; free of gasoline or
other solvent vapors. Do not operate the compressor near the spray area.
1)
2)
3)
4)
5)