Motion 42-02-S028 - Manual (Page 10)

MCE Universal Serial Network
4 Manual # 42-02-S028 A1
Configuration
After connecting power, “INITIALIZING BOARD COMM” will appear on the USN-BASE
assembly LCD display.
Device Type
Note
It is important that all communication wires are disconnected from the USN board before
changing the device type. Make sure all ethernet, CAN, and serial cables are disconnected.
When making changes to settings:
• Press N to cycle through menu
• Press S to select
• Use S to move cursor
• Use +/- to change selection
• Press N to go to save menu
• Press S to save
To begin configuration:
1. Set only the F7 switch UP.
2. Press N until Device Type is displayed.
3. Press S to select. Supported Device Types are:
• IMC types:
• Swing Panel Group
• Swing Panel Simplex
• PCA types:
• PHC Simplex Standard
• PHC Simplex Ansi 2000
• PHC Duplex Standard
• PHC Duplex Ansi 2000
• PTC Simplex Standard
• PTC Simplex Ansi 2000
• PTC Duplex Standard
• PTC Duplex ASME 2000
• Motion 3000ES Escalator Controller
4. Select the Device Type.
5. Press N to go to save menu. Press S to save.
6. After the device type has changed, place the F7 switch down.
7. Reset the USN board by pressing the RSTA button.
8. After the device reboots, confirm new device type is selected.