Macsense Connectivity XRouter Pro - Manual (Page 24)

4.2.2 IP Access Setting
The IP Access Setting page in the XRouter Pro can block a user defined
IP range from accessing specified ports. This feature is useful when block-
ing Internet services that you do not desire on your network.
(See Figure 4.2-2)
Figure 4.2-2
The IP Access Setting sub page contains four sections. To enable the IP
Access Setting feature, you must enter information into the following sec-
tions:
Filter Group (1-5)/LAN IP Range: In this section, you will need to input the range
of LAN IP addresses for which access needs to be blocked. You can have up to 5
Filter Groups.
NOTE: The IP Range of one Filter Group can not overwrite the IP Range of
another Filter Group.
Protocol Type: In this section, you will need to select the type of protocol that
needs to be blocked from the pop -up menu. The choices are TCP, UDP, or
Both. If you are uncertain about the type needs to be blocked, select Both from
the menu.
Blocked Port No: In this section, you will need to enter the individual port num-
bers to be blocked. Up to 5 individual ports maybe be entered in this section for
the given IP Range.
19
Chapter 4 - ADVANCED CONFIGURATION