Macsense Connectivity XRouter Pro - Manual (Page 27)

4.4 Device Administration
This page displays information on the firmware version of the XRouter
Pro. You can also change the password, reset the device, disable, or
enable external administrative access to the web based configuration of
the XRouter Pro, block WAN port scanning and WAN ping responses.
(See Figure 4.4-1)
Figure 4.4-1
Block WAN Port Scanning: to block or allow external port scanning of the
XRouter Pro, select Yes or No and then click Apply.
Block WAN Ping Response: to block or allow external pinging of the WAN IP of
your XRouter Pro, select Enable or Disable and then click Apply.
Restore the XRouter Pro’s factory original defaults: select Yes and then click
Apply.
External Admin Access: to enable or disable external admin access to the
XRouter Pro, select Enable or Disable.
NOTE: IT is recommended to change the default “admin” password of your
XRouter Pro for the security purpose. This is especially recommend if you
intend to administer the router from outside your network and enable the
External Admin feature.
22
Chapter 4 - ADVANCED CONFIGURATION