Mark Of Fitness MF-180 - Manual (Page 5)

open close
Thread the left and right attaching tabs
through the attaching loops on the sides
of the monitor, making sure the sensor
wire points towards the finger wrap.
Press the hook and loop fasteners
together firmly to make sure the monitor
will not fall off during use.
Put the sensor button (marked with in
the figure) into the sensor hole (marked
with ).
The sensor button should appear on the
surface of the band.
INSTALLING BATTERY
B AS IC OPE RA TIO N O F THE MON ITO R
ATTACHING THE MONITOR TO THE GLOVE
PUTTING THE MONITOR ON YOUR HAND
Open the battery cover by turning it with a coin in the direction of the
arrow until the two triangles align.
Remove the battery cover and battery by tapping the monitor
against the palm of your hand.
Replace with a CR2032 battery with the positive (+) side up.
Carefully reinstall the battery cover by aligning the triangles on the
cover and body, angling the triangle in first, then allowing the cover
to drop into place. Secure by turning opposite to the direction of the
arrow until motion stops.
To maintain water resistance, be careful not to dislodge the rubber
ÒOÓ-ring from the battery compartment. Do not to allow dirt or
debris to remain on the ÒOÓ-ring. Do not force the battery cover
into position, small tabs that maintain the seal may break off.
Place the monitor on the back of your left hand.
Wrap the base of the index finger with the finger wrap portion of the glove and secure with the hook and loop
fastener. The sensor should be flat against the fleshy part of the finger, just above the crease between the palm and
the base of the finger.
Tension on the finger wrap should be adjusted to make the printed oval on the wrap into a circle.
Replace the battery when
the battery replacement mark appears.
battery cover
glove
- 6 -