MITSUBISHI ELECTRIC SR-HD5 - Manual (Page 22)

Mitsubishi SR-HD5 HD DIRECTV Plus Receiver
Page 2-4
Note: In order for the Advanced Program Guide™ to receive the correct
listing of local channels and local program information from DIRECTV,
make sure you select the correct zip code, cable provider (if connecting a cable
TV service) and Area (if using a terrestrial antenna). Refer to Chapter 4,
“Setting Up the Satellite Dish Antenna and Terrestrial Inputs.”
Using both the IN FROM ANT connector and the SATELLITE connector
with a diplexer, you may connect one antenna and one cable TV service cable
at the same time, however this HD receiver and the Advanced Program
Guide™ cannot support two antennas connected or cable TV service
connected in two places at the same time.
HD Receiver and HDTV Monitor
Follow these steps indicated by the diagram following this text.
1) Connect the satellite dish antenna and terrestrial antenna or cable service to the HD
receiver following instructions in “HD Receiver and Satellite Dish Antenna with Terres-
trial Antenna or Cable Service” on page 2-3.
2) Connect one set of Component Video Cables (one green Y connector, one red P
r
connec-
tor, and one blue P
b
connector) to the back of the HD receiver using the connections
marked Y, P
r
, and P
b
. Connect the other ends of this cable to the back of the HDTV
monitor using the HDTV input connections marked Y, P
r
, and P
b
.
Note: Connect the Y, P
r
, and P
b
connectors of the HD receiver only to the Y,
P
r
, and P
b
connectors on your TV that are compatible with HD signals in the
1080i scanning rate and that comply with the EIA 770.3 signal standards.
Refer to your television owner’s guide for verification.
If you have one of the following models of Mitsubishi HD upgradeable TVs: VS-50800,
VS-50803, VS-60803, VS-70803, VS-80803, WS-65903, or WS-73903, you will need to
obtain a model RGB-CV10 signal adapter. This adapter will convert Y, P
r
, and P
b
signals to RGB H & V signals and is compatible only with selected Mitsubishi TVs. The
adapter can be purchased at www.mitsubishi-tv.com or by calling 1-800-553-7278.
3) Connect one set of audio cables (one white left audio connector and one red right audio
connector) to the back of the HD receiver using the connectors marked AUDIO L, R.
Connect the other end of the audio cables to the back of the HDTV monitor using the
audio inputs.
Note: This connection allows the use of the speakers in the TV to hear the
sound.
4) Optional: Connect one set of audio cables and a video or S-video cable to the back of the
HD receiver using the connectors marked AUDIO L, R and VIDEO or S-VIDEO.
Connect the other end of audio and video cables to the back of the HD monitor using the
AUDIO and VIDEO or S-VIDEO inputs.
Note: This connection allows you to send standard 480i signals to your TV. If
you own a Mitsubishi HD upgradeable TV, select INPUT 2 for this
connection.
For better standard definition performance, if your TV has an S-VIDEO connector, then
use an S-video cable instead of the yellow video cable.