MITSUBISHI ELECTRIC SR-HD5 - Manual (Page 41)

Setting Up the Satellite Dish Antenna and Terrestrial Inputs
Page 4-5
Local Provider Area Options
Area 1 You have connected a standard VHF/UHF antenna for receiving your primary
analog and digital terrestrial signals. The ZIP Code entered here will specify
what terrestrial program information should appear in the Advanced Program
Guide™.
Area 2 Area 2 may be a neighboring city or distant terrestrial station you wish to
receive from the same VHF/UHF antenna used in Area 1. The ZIP Code
entered here will specify what terrestrial program information should appear
in the Advanced Program Guide™.
Cable TV You have connected a cable television service. The cable provider entered
here will specify what cable program information should appear in the on-
screen program guide.
System Test
The SYSTEM TEST screen will display the signal strength of all of the transponders on the
satellite that have been selected on the Signal Source pop-up menu. It will also indicate the
quality of the signal transfer between the dish antenna and the SR-HD5 receiver. The SYSTEM
TEST Menu offers the following options:
Begin Test Starts the receiver test, which provides basic status information about the
receiver. The test may take up to one minute.
Cable Test Tests and displays indicators of all transponder signals from the satellite
chosen by the Source pop-up menu.
Upgrade Checks the status of software upgrades that DIRECTV periodically performs.
Highlighting the System Test button on the INSTALLATION screen and pressing the key
on the remote control will display the SYSTEM TEST screen. Using the and keys, highlight
either the Begin Test or Cable Test button and press the
key on the remote control. After a
short period of time, the results of the test will be displayed.
You should perform the cable test for each of the
satellites supported by the dish antenna you selected in
the DISH TYPE screen. If you are setting up your
system to receive signals from Satellites B (110°) and
C (119°), you will need to change source satellites
between each Cable Test.
Note: Not all of the transponders on Satellites
B (119°) and C (110°) are currently being
used. On Satellite B, for example, you may
receive NA (Not Available) indications for
several transponders. This is normal.
SELECT
▲
▲
SELECT
The SYSTEM TEST screen